Parts
3D Technologies
Filaments & Resins
New Products
Promo
Outlet
EU VAT exception

Flex TPU 98A RepRap PT - 1.75mm 500gr - Glow in the Dark Pink

29.00
8 in stock
SKU: TPU175RL5
Cat.: Flex
trademark/Compatibility:
Flex TPU 98A RepRap PT - 1.75mm 500gr - Glow in the Dark Pink
Flex TPU 98A RepRap PT - 1.75mm 500gr - Glow in the Dark Pink
Flex TPU 98A RepRap PT - 1.75mm 500gr - Glow in the Dark Pink
Flex TPU 98A RepRap PT - 1.75mm 500gr - Glow in the Dark Pink
Flex TPU 98A RepRap PT - 1.75mm 500gr - Glow in the Dark Pink

Item Description

Color information

Fluorescent Pink that glows in the dark in pink or salmon, to glow in the dark it needs to absorb light first and the place must be quite dark. It can be placed next to a lamp for a few minutes and after turning off the light, you will be able to observe the event! As we know, the intensity of luminescence depends on the base color.

This colourant is not recommended to be in contact with food.


Filament Features


Flexible TPU type:

Printing temperature: 210-220Cº (220ºC recommended)
Table temperature: 0º to 60ºC
Deformation temperature: 138ºC
Speed: <= 75 mm/s between 30 to 40 mm/s

It can be used on a cold glass table and lacquer or baton glue, depending on the size and shape of the object.This material adheres well to the table.



The 95A settings works well for the 98A TPU.



The material can print at 75mm/s if you consider the following tips with green and blue hotend options:
Imagem
Extruders must have springs to help press the filament close to the toothed gear, although the drawing does not show it. The recommended extruders are Green and Blue. Red ones are not recommended, although some people can still print with TPU.

In some cases of humid storage locations, it may be necessary to dehydrate the filament for +/- 8 hours in a fruit dehydrator at 65ºC.

!Attention Users with PEI surfaces!


Before you start printing with Flex on a PEI surface, clean the nozzle of previous material - preheat the nozzle and load PLA to remove any other material. When loading the Flex, loosen the extruder screws. Keep in mind that when printing with Flex, the automatic filament switching function may not work correctly.


Nozzle temperature: 230°C
Bed temperature: 25 - 60°C (the higher the object the higher the temperature should be)
PEI Surface Preparation: Make sure the surface is clean. Some flexible materials can fuse to the PEI film and require the use of Stic or Baton glue as a separator to prevent damage to the PEI film.